Sleek, minimalist design meets easy installation. The Monorail practically hugs the ceiling. The Pass Through combines a sleek new design with the ability to use 1" standoffs and ease of installation. First, the installer mounts and wires the upper canopy in much the same way a standard line voltage pendant would be mounted. Second, the installer connects the rail connector to the rail. Finally, the installer snaps the lower canopy into the upper canopy without the need for any tools. The electrical connections are made automatically due to the mating components. The transformer bay is housed completely in the bottom canopy, so should there be any problems with the transformer at any time, only the bottom canopy would need to be removed. The upper canopy and the entire Monorail run can remain in place. Itâ€™s that easy. This single feed pass through surface transformer converts standard 120 line voltage to 12 volts to provide the necessary voltage for powering a Monorail low voltage lighting system. It can power lamps totaling up to 300 watts and features a fast acting secondary short circuit and overload protection that will safely turn the system off should a short occur. Once the short has been removed, the unit can be reset by simply flipping the wall switch off and on.
This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box (not included). Rail is installed through the transformer to bring power to the run.
The only rigid standoff that can be used with this surface transformer is the 1" rigid standoff (sold separately). 12 volt transformers require the use of 12 volt lamps.